The water in the country

To live in the country or in a rural house without running water and hot water is not very comfortable. For the construction of the house of water requires at least minimum knowledge about the work.





In the article, I have identified the following key points, without which it is unlikely that the system will work fully.

1. The installation of plumbing made of plastic pipes.

2.The water supply is from a well to a depth of 11 m. this job cheap and high quality submersible pump Italian production with a capacity of 100 l/minute and maximum head of 46 m water column. The pump is placed in a plastic tank for drinking water, which subsequently will prevent the raising of sludge from the bottom of the well if the water level in it drops.

3.To maintain a constant pressure in the system installed accumulator. Accumulators are for hot and cold water. The author has established the system of cold water supply pressure tank for hot water, because the rubber in it is higher quality and lasts longer. The volume of the accumulator is chosen by the number of cranes — about 20 litres on tap.

4.On the intake pipe of the accumulator has a special relay that turns off the pump as soon as the pressure exceeds the set value.

5. The pump is installed a self-cleaning filter that does not require disassembly when cleaning.

6. Installed a check valve to prevent drain water back into the well when the pump is stopped.

7.For hot water purchased 100 liter German water heater "Stiebel" complex heating element having a heating surface of 10 times larger than conventional Heaters. The water heater has a rod of a special material which prevents formation of scale. Non-return valve is mounted outside.

8.Provides protection from freezing. To do this, drain the water from the heater and of the accumulator is run through the drain valves. Because in the system the water is clean, the grates back into the well. To do this, below the level of freezing of the water in the well is installed using a tee to the drain valve and solenoid valve. From pipeline residual water merge through the valve located in the utility room.

9. Drain well depth of 3 m is dug out near the house. It includes one tube which are connected to plum from the sink, shower and washing.

 

System of independent water supply at homethe Most important convenience in the house is the plumbing. But in rural areas, not every home plumbing solved the problem. To solve this problem will help the system of independent water supply at home, the proposed I. Kasian. The system is simple to manufacture and reliable in operation. The water flow in the system is under pressure from the borehole, well or an open pond.





The system of Autonomous power supply consists of a centrifugal pump(4) and a sealed tank(1) volume of not less than 80 liters, able to withstand the pressure. The system can operate both in automatic and manual modes. Automatic operation ensures electric contact pressure gauge(2). The figure also shows: a box of electrical equipment(3), valve(5) check valve(6), a funnel for pouring water when you first turn on the motor(7).

Pump set at the well in the pit. This pump location ensures convenience in maintenance and winterization in the winter. A sealed tank in the house or in the basement.

Electrical (circled in the diagram by the dashed line) is mounted in a metal box.





The lower and upper limits of excess pressure regulate with the help of electrocontact pressure gauge BP. The power supply and short circuit protection is a circuit breaker QF. For circuit change-over in automatic or manual use a toggle switch SA. KM — contactor, KV—, intermediate relays, the M — pump. published

 

P. S. And remember, only by changing their consumption — together we change the world! ©

Source: www.liveinternet.ru/users/3790483/post382620597/

Tags

See also

New and interesting