Hemp are different ...

30 photos

Description of what happened looked intriguing: "My uncle recently caught sideways stump, flying off the track at speed on his FF2».

Hemp, of course, we have seen ... To recall the "Shishkin Les" ... But to create such a tin lizzie ...
There was a suspicion that the stump was ... um ... of concrete reinforcing bar ...
In general, look and be afraid ... the stumps



Oh, how vmyali - and went to the floor, and the threshold of the rack ...



The back door bulged



And even climbed the hood



But the most unpleasant awaited us later - when we measured the body - the car went "banana»
Ie Shot from the left side - blurred gaps starboard
And even at the front of the roof room



Parts we look started with the bottom



Here are some nice bottom handbrake we found and delivered



Then, ha ha, very interesting situation - we had to buy two racks of central, because It was not anywhere on the dismantling of individual threshold to FF ...
And to make a car like the client and us. A place where the reception is cut off from the bottom white - were not given the opportunity to fully restore the threshold ...
I had to take a second rack in reserve - to increase from the first part of her stand



With a door's simple:



We climb into the cabin with the passenger seat, and we call on the slipway



It is seen that stump managed to somehow damage the hood and more to the right ...
Oh, these green corners of Mother Russia ...



Now we start to think out how to open the driver's door to us to look more at the injury site



This works only half an hour with the help of the Bulgarian instrument



The door, you can not sell expensive



Runners, which drives the driver's seat and an amplifier, which is mounted on this chair - to hush up the good



Gaugeable body line and fixed on the clamps Stacking



Grabbing a red clip of Gone central rack - trying to bring it back into place as far as possible



Just pulling the rack (and it does not last, and only spring) - we understand that everything is not just with the "stump»
Remove the seat, a little later and will remove the entire interior, sawing threshold ...



Dissolve the threshold, so that you can easily pull the threshold and rack



Without the clip so you can pull the chain - here's the hook in the forehead would



Clip cling and pull with all his strength



Pull straight with scary creaks and breaks
Scary at this point for the poor stump that with him it was ???



We stretched out on as much as we could. Then simply stretches and breaks already.



Okay, beaten with sledgehammers on the floor - it has been crumpled, and remained
Disassemble the amplifier, which is attached to the driver's seat



Pulling the geometry of the left side, not sparing the rack, because it anyway change



Pull the two vectors - the left and down, here you can see the bottom of the clamp to pull down



We put the door



And ensure that the gaps become ideal
And they still are not perfect - that's the gap back door with the rear wing - is different from the left side



... And right ...
And the most unpleasant fact that - in both cases, they did not like Henry Ford conceived
Banancheg, but ...



To get rid of the banana - we still have a lot to do
Cut the old central post



Cut the crumpled remains of the threshold and the bottom of the crumpled

Posted in [mergetime] 1339085748 [/ mergetime]
Here's how the left side sawed



Disassemble the remains of the cabin and close the tarp back sofa + torpedo



Here's what we cut like surgeons in the corner - the severed body parts strewn



Now freed, the body feel better - easier stretches metal
Pulling the front rack, normally closed to the hood began



Tightens mudguard front left



Power threshold lonely sticking, but at its rightful place sticks



A large hole in the bottom



We take our first donor threshold



And applying



We catch crocodiles



And the search begins of how the desk should be properly



Where required - More tightens



The bottom threshold
stykuya


Tightens the right side of the car, is not brewed the left - there are a few millimeters divergence gaps



We start brewing the left side



The hole we grandiose



Brew amplifier threshold to the bottom - in one piece - take a patch cut from the donor organ - bottom



...



Treat the inside and tsinkarёm brew outer metal - patches missing on the threshold of making the second black rack



Here we have turned this elegant left side - 3-yoh pieces



...



Black Front, which still need to trim - sadly remained standing in the corner



There's also found refuge original crumpled desk



And we put in place Align the amplifier for the driver's seat, we clean the welds on the verge



Handle for painting



That doorway tailgate



Roof after "banana»



Hood after the "hemp»



As stump could hurt more and the wing? - It is, the trip took place, probably for "Shishkin Forest»



Long or short - to prepare and paint
First, separate the door from both sides



Then the side of the body



That's how nice to get our region as a result of repair



Puts Carpet



And collect the whole body



That is what we have after washing:



...



...



...



Oh yes! I almost forgot the culprit accident ...
According to eyewitnesses rasckazam drawn sketch of the suspect:



Source: ">