As the rabbit house I did!

In recent times he appeared in our family that's a crawl! And for him it was necessary to make a cozy living space. Actually the process of establishing itself and I want to show.

Will be 29 photos





I made the most of the materials that have already been. DSP from the old kitchen units.



Drill.
[3]



Zenkuem
[4]



Again drill
[5]



Putting
[6]



The wall in the house decided to make from the remnants of the laminate.
Mark up, sawing
[7]



Laminate glue
[8]



The side walls must be continuous. I decided to make the frame of the bar. Sawed even without miter box, almost eye. (So can a little crooked)
[9]



Side ready
[10]



The previous picture shows a roll of mesh. From it cut a piece of the correct size, nailed stapled
[11]



The front made on the same principle, bottom fastened on piano hinges.
[12]



All sides closed grid, started to cover. I cut out of plywood
[13]



Strengthened rails
[14]



Adhesive foam
[15]



5cm foam rubber and glue the top sintepon
[16]



[17]



And on top leatherette (pre-made out of two colors)
[18]



By the front door locks are bought here (as seen in the photo frame is made of plywood, cut to decorate the side walls)
[19]



Which also successfully Cushioning 1cm foam, synthetic padding and kozhzamom
[20]



the same process with a frame for the front door.
[21]



The side of the door is also closed kozhzamom
[22]



I spread a linoleum on the floor and made "skirting" of aluminum parts. Fix the front panel to the door via screws, twisted inside the house.
[23]



Likewise, fixed and side panels. The cover is also attached to the piano hinges. And that's what happened.
[24]



I forgot to take a picture of how screwed to it :) wheel on the photo is not visible :(
[25]



[26]



That's the new home :))
[27]



And this is my wife and Dexter (So his name) :))
[28]



there is still one last photo
[29]
That's all I wanted to say!



Source: ">