Air conditioners also require refueling!

Did your air conditioner stop working? Do you not feel the usual coolness from his work in normal mode? One of the reasons for this may be the need to refuel the refrigerant. Freon leaks are not an emergency. The refrigerant leaks out of the air conditioner on a regular basis, but in so tiny portions that the lack of coolant begins to affect the operation of the device only after a few seasons. We'll figure it out.
Freon protects air conditioners from heating. Overheating of climatic equipment is a sure way to refuse to work or break down. In order to avoid this, it is necessary to regularly check the level of refrigerant. You don’t have to do this too often to burden you. But it will help to save time and money, as well as to avoid a situation where the search for a company carrying out high-quality repair of air conditioners in Moscow becomes your urgent problem.

How do you know it's time to refill Freon?

The main “symptom” of the lack of refrigerant is insufficient cooling of the air in the room. Or, on the contrary, you will notice that your air conditioner is “threshing” with all its might. A hint can also occur sliding of the inner block. The frost on it is an excuse to go for Freon.

Where do you get the refrigerant?

Freon is not a deficit. It is a gas that does not pose any danger to human life and health. Therefore, it is sold in open access in ordinary stores that sell climatic equipment, related products and other products on the topic. In addition, you can order freon for your multi-split system through the Internet in virtual stores. It makes sense to buy it in balloons. Volume varies. We recommend taking more. Miniature 300-gram cans are an empty idea. They're like a lighter. To an air conditioner, it's like a mosquito bite to an elephant.

Freon filling

Equipment must be prepared before refueling. Set it at +18°C and cold mode. From the service port (a large pipe at the street block) you need to remove / open the lid, connect the pressure gauge and container with the refrigerant. Each device has a special plate on the skin, which contains information about how much freon it should contain. After this manipulation, we put the intensity of the equipment at the usual level and with the help of a conventional thermometer find out when freon is enough. The thermometer went up - that's all, normal.

How do you avoid problems?

Freon flows where the joint of pipes is not sufficiently sealed. This is a problem of poor installation. Therefore, it is necessary to start solving future problems at the time of installation. The more competently installed, the remoter the moment of refueling. The installation is for professionals. And the gas station in a good way is better to trust the specialists. In addition, climate equipment requires regular diagnosis. To warn is to avoid! Well, you have to choose the right equipment.