Skateboard swing for 20 minutes with their hands

There was no way to know who first came up with to make a swing out of a skateboard. But we can say for sure that anyone can easily handle this project, and that the children will love this attraction. Want to try?

You need:

• Old skateboard
• Sturdy rope
• Large drill bit for the width of the rope
• Two large elongated shape carabiner with screw fastening

The first thing to do is remove the wheels and their mounts from a skateboard.



Then drill two symmetrical holes on both sides of the Board.



Take a cylindrical bar (this can be handle from any agricultural tool) and cut it in half. In this photo we see the specifics were a little wider than a skateboard.



Be drilled each with two holes on two sides, retreating about three inches from the end.

Now you need to cut the rope into two parts. Each rope is thread through the holes on both sides, as shown in the picture.



Above each hole attach a rope knot. But do not tie knot too tight – you may then have to adjust the length.



Now equip your swing handles bars.



The bars also attach nodes above and below.



Attach the rope to the metal clasps, so that it is not frayed. You might need to tie knots to even out the swings. published

 

P. S. And remember, only by changing their consumption — together we change the world! ©

Join us in Facebook , Vkontakte, Odnoklassniki

Source: www.forumhouse.ru/articles/garden/6640