Wind turbine of 3D-printer: AirEnergy3D

Last month I wrote about wind turbine WindPax . This marching variant that produces 25W and able to charge your smartphone. Now on Kickstarter introduced another ветровую turbine , this time from Poland and printed on the 3D-printer.

Photo of the first prototype.




Installation is possible on any surface.


Use immediately or can accumulate.


Before going to just disassemble and clean the turbine in a backpack.


Minute savings: Spend outlet of the wind turbine and save money.


Basic set AirEnergy3D Basic Kit will cost about $ 350. It will include components that can not be printed. The rest will have to do the same at home with your 3D-printer.

What is the general advantage of this turbine? Most current devices of this kind, if they are portable, can only charge the batteries of smart phones, navigation devices and other small devices. Problems arise when you need to charge the full laptop: too long to wait. And still the same WindPax not replace the outlet in a country house. While vendors promise AirEnergy 3D power of 300 watts - so that the garage light, and camping out.

Source: habrahabr.ru/post/233641/