Keychain on request.

I asked a colleague to make it stick, chose the time, and away we go.
Immediately apologize for mistakes and foul-quality photos, as I filmed on the door hinge.





2. keychain took two pieces of plastic, white, and pearl (round).



3. Come up with design depicting in AutoCAD, PrintScreen-ohm know how to use, but laziness. =)



4. depict insert



5. load logo softinu for the laser.



6. expose the needed parameters.



7. Unfortunately due to the nature of this machine, attach the workpiece is extremely inconvenient.



8. laser operation.



9. output, it looks and smells terrible.



10. General view of the base box, and a scrap in the form of heart, too, to adapt.



11. This will be the back of the remote control



12. paid, the photo shows bad, but there is relief.



13. try on straziki



14. Here is such a scrap.



15. to scrap as nanoshu logo, a strong decrease.



16. after painting in blue. It is painted with special paint.



17. abrade or as they say "vintazhiruem»



18. The rear side.



19. try on the insert.



20. insert screwed, have to redo, but it seems like a trim fit.



21. All color red.
(sorry Inet tupit)



22. The assembly with a new insert.



23. strazikov size visually, 2.4 mm in diameter.



24. Here they are, the most foul, this glue from your fingers - sausages.



25. straziki, trim and insert glued, it is small ...



26. cut out of white plastic dyed black in another box ...



27. select the photo. and put on a black and white box (also laser)



28. The obverse keychain.



29 rear storona.Razumeetsya Keychain can be done much easier and faster, but I was wrong. The photo looks like not a fountain, but I assure you, in reality, everything is fine, I do everything possible to kick.



Source: ">