Stitched shoes

Please do not break. Total 13 photos.
I have leaky shoes. It was a pity to throw, so decided to hem them. Below is the process itself.

For this we need: Yarn nylon 3 UAH beam; awl 4 UAH; hook (1, 5 mm) 5 UAH; glue "Moment" - UAH 6;
TOTAL = 18 USD = 2, $ 5.





The shoes flaked off a piece of sole - you need to "treat." Actually before flashing glue fill all the "problematic" places on the joints. Dries it long enough, just have time to sew shoes.



We take out the insole, take out the laces



From hank kapron thread cut off 2 pieces, more than a shoe sole approximately 15-20 cm



Recommended to start a file of the inside of the shoe, more likely there is less load, and the thread is not raspletёtsya.



First awl pierce through hole



Two harvested piece of knotted string. Through the opening, outside hook pull out one end of the thread.



1-2 cm make another hole and pull out the hook through it to the outside of the loop thread obuvki (thus it will have an internal thread). This loop is threaded tail outer thread (see. Photo).



The first seam is almost ready.
During the two-tail pull, whatever seam converged (see. Picture)



And so it stitch by stitch ...



Try pulling the tabs are not large, otherwise the internal thread you quickly raspletetsya and tear.



Here



Result. Each shoe 20 min.

When finished flashing shoes, the thread from the inside, you can simply tie a double knot.
That's all I wanted to say. :) All great weekend guys !!! :)



Source: ">