As a beginner rukozhop repairs lamp Bashny.Net

I burned my energy-saving lamp. In principle, the business somehow at $ 100, but I wanted to try and fix it. But since I really do not solder previously held in the hands, then looking at a couple of splints for soldering and repairing lamps, I got down to business.
15 photos with my comments





2. When opening the lamp failure is already evident - swelled the capacitor.



3. I plucked clippers this Conder, and went to the electronics store of the same. Buy a couple of stuff on the safe side. They cost me 12 rubles.



4. It's time to solder. I took out the Soviet solder, and it became warm.



5. Legs swollen Conder vypayat successfully.



6. At this stage, I ran into a problem - I do not really know the polarity markings on the board. I climbed to google. I found the right info, designations, and without problems a capacitor soldered into place.



7. It looks like my first soldering on the other side.



8. bites clippers extra long legs Conder.

Posted in [mergetime] 1392644437 [/ mergetime]
9. And here I thought it would be the easiest part of the job - to fasten the wire filaments on pins. I never in my life so do not wrong. The first 2 screwed I like the rules.



Forgot to attach the ninth picture, sorry))



10. But the other two I could not give. Meshal svezhevpayany Conder, and room to move was not enough. Dokrutili that both broken off delays & gt; _ & lt;



Source: