How to trim roses in the spring

Every year when spring comes, the roses pruned.The reasons why cut roses:

1.Adjusting the shape of the bushes after the previous growing season. Last summer, branches of roses grown in the wrong direction. This is accomplished by pruning those branches that were violated in the form of bushes.

2. Trimming the bushes is made so that the intent of the gardener:

• the bushes will produce large, single flowers on long stalks;
• the bushes will produce many flowers on many stems. In this case, the flowers will be smaller but in large numbers.

 

3. To rejuvenate the Bush by cutting old branches and causing the shrubs to produce new shoots.

After the probability of frost will disappear, and the kidneys have not yet blossomed is the right time to do pruning of roses.

First, carefully inspect the roses. All the branches that have grown inside of the bushes should be removed. This will help to thin out the rose bushes and to enable the best ventilation. Then you must remove it before live wood branches that were damaged or died over the winter. On very tall bushes make pruning all sickly shoots. If the hive is weak, these shoots leave too, but shorten the branch of the at least one kidney. It stimulates growth and strengthen the plant itself. Pruning roses should be such that the existing roots could feed all the branches of the aerial parts of bushes. This is an important condition for cropping. In this case, rose will normally increase shoots and good blooming.

How to trim roses FOR GROWING LARGE FLOWERS

In addition to sanitary pruning roses with large flowers, cut them for growing flowers for cutting. In this case, each branch that you left you must escape cut off so as to leave 3-4 buds. It contributes to the development of vigorous sprouts from the small amount of left kidney. On such long shoots formed large flowers.

Pruning roses for GROWING FLOWERS IN the flower BED

If you want roses bloomed profusely in the flower bed, pruning is necessary to make so that is left after pre-trimming the shoots to leave on 3-6 buds for growth. As a result of trimming will appear a lot of flowers, smaller and smaller stalks.

Pruning rose type FLORIBUNDA OR HYBRID TEA ROSES for growing in the flower bed

If you want to create a lush Bush of these types, then you need to carry out formative pruning. Depending on how you imagine the future in the Bush in this relationship and produce a crop. First, do a sanitary trim, and then proceed to the formation of a Bush. It's hard to say how many buds you need to leave. It may be 3, and 6. Everything depends on the Bush you choose to form. If suddenly reduced flowering and growth of such bushes, the later will have to do a more severe pruning roses.

Pruning MINIATURE ROSES

Basically, miniature rose bushes pruned as bushes hybrid tea roses. It is sanitary and formative pruning. Leave 2-3 buds on the branches. The length of branches not more than 4(10cm). If you do not cut the plant, it comes much later at the time of flowering. In the summer remove the faded flowers, dry branches, withered leaves. This is done in order to prevent the pest or disease and in order to improve the decorativeness of the Bush.

Pruning of CLIMBING ROSES

Spring pruning of climbing roses is made only at the ends of branches. If the plant is over 4 years old, the old shoots are cut completely to the base of the soil after flowering, young shoots do not touch, and within a year are not pruned, because their ends will bloom rose the following year.




TIPS FOR PRUNING ROSES

1. Early timely pruning stimulates flowering rose bushes. Too early pruning until after the advent of frost slows down the flowering of roses.

2. Late pruning roses slow start to the growing season.

3. After pruning the rose bushes to feed.

4. In order for the buds started to grow on climbing roses, you need to tie up a young branch in a horizontal or inclined position.

5. All of the slices are more than 1 cm it is necessary to gloss over garden pitch or liquid Novikov.

6. After pruning the plants should be sprayed with 1% solution of copper sulfate (100 g per 10 liters of water) or 1-3% solution of Bordeaux fluid.






These groups of roses, as Spinosissima, Rugosa, Gallica and hybrids, Moschata pruning almost do not need. The flowers are produced on lateral branches of biennial shoots and older branches. Pruning of roses is produced in the event of damage to branches or natural dying.

It is best to cut with a knife in order not to crush the branch. Knife for pruning of roses should be sharp. Before cropping disinfect it.

Cut off is at a height of 5-8 mm above the kidney to a future escape had not been dried. Cut on the bias to make from the kidneys.published

 

P. S. And remember, just changing your mind — together we change the world! ©

Source: //vk.com/dachahitrosti?z=photo-94669436_456246456%2Falbum-94669436_00%2Frev