283
Operation of traction batteries
The battery is a current source, designed to accumulate and give a fairly large amount of electricity to the consumer. However, this device is absolutely environmentally friendly. If the battery is properly maintained, it can last much longer than guaranteed by the manufacturer. In addition, the operational life of such devices can be further extended with repair. Service specialists carry out diagnostics of batteries and their subsequent recovery, then another two years to buy a new power supply.
The battery life is increased in cases when owners perform a number of mandatory operating conditions — timely implementation of the charge load in the normal range, using the device only under the condition of normal temperature environment, the use of qualitative and well-chosen charger prevent deep discharge, fast and effective elimination of occurring faults.
Reduce the battery life factors such short, frequent overload, use for topping plain water instead of distilled (in this case, the electrolyte includes various impurities). Adversely affect the battery performance and other violations of the conditions — long stay of the device in a state of full or partial discharge, the charge is too high voltage, long-term excess operating temperature, the assumption of frequent deep discharges.
There are certain rules that must be followed during use of the traction battery. It can not be permanently left empty. Immediately after discharge is recommended as soon as possible to implement its charge. Discharge more than 80 percent of the rated capacity of the device should be avoided. The density of the electrolyte in the cells should be not less than 1.13 kg/l to prevent deep discharges, it is necessary to constantly monitor the status of the battery during its operation. The temperature of the electrolyte should never exceed 55 degrees.
Before you put the device on charge, it is important to open it, that is the container lid or other closing device must be open. Close battery can be no earlier than 30 minutes after the procedure charge.
P. S. And remember, only by changing their consumption — together we change the world! ©
Source: 3dp.su
The battery life is increased in cases when owners perform a number of mandatory operating conditions — timely implementation of the charge load in the normal range, using the device only under the condition of normal temperature environment, the use of qualitative and well-chosen charger prevent deep discharge, fast and effective elimination of occurring faults.
Reduce the battery life factors such short, frequent overload, use for topping plain water instead of distilled (in this case, the electrolyte includes various impurities). Adversely affect the battery performance and other violations of the conditions — long stay of the device in a state of full or partial discharge, the charge is too high voltage, long-term excess operating temperature, the assumption of frequent deep discharges.
There are certain rules that must be followed during use of the traction battery. It can not be permanently left empty. Immediately after discharge is recommended as soon as possible to implement its charge. Discharge more than 80 percent of the rated capacity of the device should be avoided. The density of the electrolyte in the cells should be not less than 1.13 kg/l to prevent deep discharges, it is necessary to constantly monitor the status of the battery during its operation. The temperature of the electrolyte should never exceed 55 degrees.
Before you put the device on charge, it is important to open it, that is the container lid or other closing device must be open. Close battery can be no earlier than 30 minutes after the procedure charge.
P. S. And remember, only by changing their consumption — together we change the world! ©
Source: 3dp.su
Inside an abandoned school where young fascists were raised
Protein of Huntington's disease are necessary for proper brain development