251
Smart water heater will save up to 40% energy
Two million five hundred thirty thousand seven hundred seven
Boiler for hot water at 60 or 100 litres, installed in your apartment or in the basement consumes a lot of power. But tankless water heaters will pull a lot of water until it is heated.
New tiny water heater promises to fundamentally change the situation and save money through new technologies.
Compact water heater called the Heatworks MODEL 1 can reduce energy consumption by 40 percent and water consumption by 10 percent, compared to traditional water heaters.
Its dimensions are only 12.5 inches (31.75 cm) 6.5 inches (16.51 cm). It is also compatible with Wi-Fi, temperature levels, duration and power can be controlled remotely.
Company ISI Technology, the Creator of the Heatworks MODEL 1, suggests that the water heater of its own development is 99% more efficient than the usual heaters, as it "uses modern electronic technology to directly energize and heat the water molecules, without using old-fashioned resistor heating elements. MODEL 1 also avoid all kinds of failures inherent in modern water technologies and additional capabilities cost the same or cheaper."
Fifty eight million four hundred sixty two thousand nine hundred forty nine
One or more units can be installed and controlled individually, thus the water intended for washing dishes, can have a temperature higher than water for the shower. The technology also works well with systems with low flow, almost instantly heating the water even at a flow rate of 0.4 liter per minute.
Characteristics:
• Speed of heating water is 7.6 liters per minute (240 V, current 48 A); this implies that the inlet temperature of water is 21°C, the output 43°C (for obespecheniya higher will need more than one device);
• Auto-switching voltage in the range 100-270 V, 50-60 Hz single phase supply. Maximum current varies from 15 to 48 and is defined by the format of the installation;
• Be pre-heated water;
• Conformity to standards UL 499, EU, CAN;
• Weight: 7.3 kg; Dimensions: length 32 cm, diameter 16 cm;
• Plug-in WiFi module for communication with computer/smartphone;
• 3 year warranty with full replacement of the device if necessary;
• No maintenance is required;
• Very quiet (it turns out that other noisy!);
• Kit includes set of universal mounts.
A wonderful solution for individual use. But as always there are nuances. If you use gas for heating, you can always install a relatively inexpensive UPS for the boiler.
Water heater with a tank assumes the supply of water at a certain temperature. But working with Heatworks MODEL 1 you will be without hot water in the event of a crash and cut the power supply. Of course, this question is to consider in advance.published
P. S. And remember, only by changing their consumption — together we change the world! ©
Join us in Facebook and Vkontakte, and we're Classmates
Source: facepla.net
Boiler for hot water at 60 or 100 litres, installed in your apartment or in the basement consumes a lot of power. But tankless water heaters will pull a lot of water until it is heated.
New tiny water heater promises to fundamentally change the situation and save money through new technologies.
Compact water heater called the Heatworks MODEL 1 can reduce energy consumption by 40 percent and water consumption by 10 percent, compared to traditional water heaters.
Its dimensions are only 12.5 inches (31.75 cm) 6.5 inches (16.51 cm). It is also compatible with Wi-Fi, temperature levels, duration and power can be controlled remotely.
Company ISI Technology, the Creator of the Heatworks MODEL 1, suggests that the water heater of its own development is 99% more efficient than the usual heaters, as it "uses modern electronic technology to directly energize and heat the water molecules, without using old-fashioned resistor heating elements. MODEL 1 also avoid all kinds of failures inherent in modern water technologies and additional capabilities cost the same or cheaper."
Fifty eight million four hundred sixty two thousand nine hundred forty nine
One or more units can be installed and controlled individually, thus the water intended for washing dishes, can have a temperature higher than water for the shower. The technology also works well with systems with low flow, almost instantly heating the water even at a flow rate of 0.4 liter per minute.
Characteristics:
• Speed of heating water is 7.6 liters per minute (240 V, current 48 A); this implies that the inlet temperature of water is 21°C, the output 43°C (for obespecheniya higher will need more than one device);
• Auto-switching voltage in the range 100-270 V, 50-60 Hz single phase supply. Maximum current varies from 15 to 48 and is defined by the format of the installation;
• Be pre-heated water;
• Conformity to standards UL 499, EU, CAN;
• Weight: 7.3 kg; Dimensions: length 32 cm, diameter 16 cm;
• Plug-in WiFi module for communication with computer/smartphone;
• 3 year warranty with full replacement of the device if necessary;
• No maintenance is required;
• Very quiet (it turns out that other noisy!);
• Kit includes set of universal mounts.
A wonderful solution for individual use. But as always there are nuances. If you use gas for heating, you can always install a relatively inexpensive UPS for the boiler.
Water heater with a tank assumes the supply of water at a certain temperature. But working with Heatworks MODEL 1 you will be without hot water in the event of a crash and cut the power supply. Of course, this question is to consider in advance.published
P. S. And remember, only by changing their consumption — together we change the world! ©
Join us in Facebook and Vkontakte, and we're Classmates
Source: facepla.net
Exhibition ecocityexpo Autumn 2015 invites professionals to participate ecourse
12 incredible things for home and garden with your own hands: the photo instructions