A ring of silver coins

First, you need a piece of steel to use as a base to work with the coin. Take a coin and postavte her on edge. Knock a small spoon or on the edge continuously rotating the coin, it is recommended that the spoon as "flattening" comes under more precise control.





Once the edge of the coin wrap to the desired height of the future ring, stop and make sure that it remains circular and save the form



Then, drill a hole in the center of the coin. As soon as the end of the drill passes through the coin - stop, the drill will clamp itself in the hole. We reserve the drill in the coin.



Then take a piece of sandpaper, first 400 units. hardness and grind the edge of a coin. Gradually replace nazhdachku to smaller and end of 1200 units. tv.



Then take a polishing paste, applied to the fabric, and begin to handle the coin.



We are doing this many times: Once you are satisfied with glitter coin, inflict Nova portion of pasta on a clean piece of cloth and start all over again.



Then take a coin and tighten the clamps in pairs, you can use pliers. Be sure to wind the adhesive tape on the pliers to avoid damaging the finish. If you have any clips of rubber or plastic - use them.



Take a drill and drill firmly holding a coin larger hole cutter.



Then take a cutter (this is a cutter) and the bore hole to the desired diameter.



Then take polishing mill (you can make the most out of felt)



... Oiling and polishing paste, polishing the inside of the coin.



As a result, spending a maximum of half an hour, you get an exclusive ring



... Which can boast such a friend or make an original gift for your loved one



Source: