A ring of silver coins with his own hands

First, you need a piece of steel to be used as a base to work with the coin. Take the coin and postavte her on edge. Knock spoon or small an edge continuously rotating coin, it is recommended that a spoon, as the "flattening" occurs under more precise control.





Once the edge of the coin wrap to the desired height of the future ring, stop and make sure that it remains circular and save the form



Then drill a hole in the center of the coin. As soon as the end of the drill passes through the coin - stop, the drill will clamp itself in the hole. We reserve the drill in the coin.



Then take a piece of sandpaper, first 400 units. hardness and grind the edge of the coin. Gradually replace nazhdachku to smaller and end of 1200 units. tv.



Then take a polishing paste, applied to the fabric, and start processing the coin.



Do it many times: Once you are satisfied with glitter coins to put the Nova portion of pasta on a clean piece of cloth and start all over again.



Then take a coin and tighten in a pair of clamps, pliers can be used. Be sure to wind the adhesive tape on the pliers so as not to damage the finish. If you have any clips of rubber or plastic - use them.



Take a drill and holding tight coin drilled larger hole cutter.



Then take a cutter (this is a cutter) and bore hole to the desired diameter.



Then take a polishing mill (you can make the most out of felt)



... And lubricating polishing paste, polishing the inside of the coin.



As a result, spending up to half an hour, you get an exclusive ring



... That can boast such a friend or make an original gift for your loved one