Safety system in an elevator

The selection of about 30 photo + slightly bukovok please do not break.

1. Putting the bulk of which in case of failure of equipment in the elevator does not allow him to fall freely, and inhibits it.





2. Collect the bottom of



3. fasten the lower part of the side walls



4. Good tighten all



5. rolled over everything and put on a strap with which this device in the elevator shaft ustanavlivaetsya



6. them we are also well-fasten.



7. establish blocking falling elevator device



8. good lubricating bolts salidolom



9. Screwing them where polozhenno



10. The same thing we do with the other Toroni device is almost ready



11. Adjust the remaining copper lining (takoyzhe effect it as the brakes in your car)



12. put a stop



13. All ties established due to not slam anything during transport, and placed in a box



14. Further cut the cable to connect electronics



15. The device for reading the amount of wind off the wire



16. The wound off after the desired number, serial number, and put the size of



17. Put in a box and pack



18. The glue on top of another box in which to kits with different facilities Furniture and bolts to install this devaysa



19. Box



20. Putting the hydraulic system by means of which clamping osuschestvlyaetsya brakes.



21. all twisted together



22. No more keys can not oboitis.



23. laid in a box



24. add the already pre-assembled kit with hoses and bolts



25. Collect the second box



26. All along the way are making a computer



27. The instruction of use, all the details of a picture, so that all will understand



28. After all the carefully laid, do cover the box with a large stapler



29. everything closes and tightens



30. and sticking sure the serial number

Dobavleno1 in [mergetime] 1285885274 [/ mergetime]
Here voopsche and all later posted a video like this device is tested.

Sorry for the quality, Fota from the phone.



Source: ">