Cooler Power Supply

Specific knowledge in radio, I do not have but a few times a soldering iron in his hand held. I hope that my report will be useful. There will

9 photos

So, we have a quiet PC with a noisy power supply. Grease cooler does not work, because all the noise from the passing air. Conclusion - the need to reduce the flow rate by reducing the speed of cooler

Take NO-NAME power supply and unscrew 4 screws from the top:





Here it is - the noise source



To start the power supply we do not need to connect it to the motherboard. This requires only one to adapt: ​​



Well, the main character - a soldering iron



The method of selection find the right resistor. Unfortunately, in denominations of Soviet times I was not strong, on this, I will be grateful if anyone decipher.
Resistance to solder consistently cooler. I decided to open the negative lead.



Output has been decided on the rear wall. To do this, you need to ream the hole



No sooner said than done!



Inside view:



Thus the speed (and noise) cooler has been reduced to two times.

Thus:
 - The zero momentum abated not work
 - At minimum speed bp blows cold air (ie, such cooling is sufficient)
 - Adjustment of outputting it makes no sense, since it is needed for a single configuration.

I have everything, thank you for your attention. Please do not criticize)))

​​

Source: ">