404
Consequences pasting car film
Dear friends and fans of tuning. It has long been known for this kind of tuning as a car cover or vinyl wrap. Glossy film, matte film, foil or a carbon protective film.
It's about what happens to the paint finish when removing the film.
+ Text 7 photos Via source
That was such a little car with vinyl, which, incidentally, had to constantly somewhere glue. Then the hostess decided to remove the vinyl. We did it as carefully as possible, and heating using professional tools for skinning. In some places, the film starred without consequences.
But on horizontal surfaces such as the hood and roof of the trouble started. Vinyl during the operation becomes very hot in the sun and the adhesive on the tape simply ingrained in the paint. When peeling off the film was shot directly from the lacquer:
Vinyl is not recommended to glue on the newly painted surfaces. By the way, this machine was purchased and a new roof on it Do not paint. Then we noticed that in the film lifting, if paint spraying were chipped, the varnish is removed directly from the cleavage:
05
06
07
But that's half woes. Templates for all cars there and the junction of two films just cut a sharp knife stationery. When the film section at best suffers lacquer. In the picture below you can see that the nail acted directly on the cut line, while peeling yellow band.
In general, if you have decided to cover the film (vinyl) his car, then think a hundred times before deciding on it.
The end.
Source:
It's about what happens to the paint finish when removing the film.
+ Text 7 photos Via source
That was such a little car with vinyl, which, incidentally, had to constantly somewhere glue. Then the hostess decided to remove the vinyl. We did it as carefully as possible, and heating using professional tools for skinning. In some places, the film starred without consequences.
But on horizontal surfaces such as the hood and roof of the trouble started. Vinyl during the operation becomes very hot in the sun and the adhesive on the tape simply ingrained in the paint. When peeling off the film was shot directly from the lacquer:
Vinyl is not recommended to glue on the newly painted surfaces. By the way, this machine was purchased and a new roof on it Do not paint. Then we noticed that in the film lifting, if paint spraying were chipped, the varnish is removed directly from the cleavage:
05
06
07
But that's half woes. Templates for all cars there and the junction of two films just cut a sharp knife stationery. When the film section at best suffers lacquer. In the picture below you can see that the nail acted directly on the cut line, while peeling yellow band.
In general, if you have decided to cover the film (vinyl) his car, then think a hundred times before deciding on it.
The end.
Source:
