Handmade flash drive

It was evening, there was nothing ... (would know what this will evolve 3 times more would have thought =))). I decided to make a new case for the stick. 20 photos on.





For this was a piece of green marble



Cut billet grinder ...



And a little ennoble Dremel for the most chips at the edges of the arrogant ...



ALWAYS use safety glasses, grit and dust in the eyes flying jet



After that leveled the surface and remove the abrasive bar edge chamfer ...



Then passes successively sandpaper with grain 360 ...



600 and 1200 ...



Cut the future cap ...



Start drill ...



And catch an unintended fakap ... not calculated with the diameter of the drill and got broke off a piece of the side wall has become too thin



We had to shorten ...



And to change the stick of the donor (HP 16Gb), because the one that was planned has ceased to be laid along the length of ...



Fill flash drive hot melt into the body ...



And before it gets cold ...
tsentruem


Then we undertake the manufacture of the end pads. Originally I planned copper, but as the piece on which is calculated not be found, we had to do aluminum. What it was donated broken CSS box of screws.



Then we write down about size and fix on superglue.



Then again passes over the range of skins for surface leveling and synchronization parts



Well, the final outcome ...



...



And finally, a set of tools involved. That's all.



Source: ">