689
House for Mike Farley
Will be 41 photos
And so. There kote one thing that likes to lie where it is necessary, in the intervals Tochal claws on wallpaper. These things need to correct an unfortunate misunderstanding.
The basis for the house will chipboard.
With beer, pencil and jigsaw - mark and cut out the bottom of the front panel and the wall.
Fastening from the inside corners.
It turns out that's such a box. It will be a door, so that it can clean up the inside.
Cut the door, and fasten the hinges
Hinges for doors with grooves under the screw heads
Racks are made of 50 mm sewer pipe. Fasten the corners, the top offset relative to the lower 45 degrees, so that the screws do not interfere.
...
Making the stairs from the bar 20x40.
...
At the next tier I would like to have a hammock, so the hinges are integrated into racks.
...
Another regiment.
We produce "penthouse" with a raise the roof again for cleaning.
...
The slots for hinges
...
Trumpet house with playground.
...
That's it, the frame is completed. Now proceed to the casing and winding.
Buy dofiga 6mm rope (hemp linen).
Sizing stand and winding.
Now proceed to pasting carpet (5 m2 +2 mat)
Cut out the template ...
And ... oops!
View from inside
...
Inaccuracies then to seal.
...
"Penthouse»
...
Now paste passages. I could not bend the carpet inside (too fat, obtained slots), so take a decorative ribbon for decoration.
...
We put in place, attached to the wall corners. With a hammock, I made a blunder, a little turned. Therefore, fixing will be used for toys.
...
...
Run kote
...
...
...
Posted in [mergetime] 1351579551 [/ mergetime]
The plan to make a soft cushion inside the houses, pick up toys.
That's all I wanted to say!
Source: ">